2007-2011 Honda Civic 1.8L A/C Compressor with Clutch CO 4918AC

Description

Fitment: For 2006 2007 2008 2009 2010 2011 Honda Civic 1.8L Note: Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally. This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system. Please add refrigerant to 70-80% without filling up. There may be noise if the refrigerant is added too much. Description： Interchange Part Number: CO 4918AC,38810RNAA02,38810RRBA01,1102577,5512349,6512349,7512349,97555,98555,10361921,1102638,638880, 38810-RNA-A02,38810-RRB-A01 Installation Method Attention Please: A/C Compressor w/Clutch CO 4918AC For 2007 2008-2011 Honda Civic 1.8L Fitment: For 2006 2007 2008 2009 2010 2011 Honda Civic 1.8L Note: Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally. This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system. Please add refrigerant to 70-80% without filling up. There may be noise if the refrigerant is added too much. Description： Interchange Part Number: CO 4918AC,38810RNAA02,38810RRBA01,1102577,5512349,6512349,7512349,97555,98555,10361921,1102638,638880, 38810-RNA-A02,38810-RRB-A01 Installation Method Attention Please: Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken. 1. Remove compressor: Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped). 2.receiver drier or accumulator, orifice tube or expansion valve. 3.Disconnect the negative battery cable. 4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet. 5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too. 6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated. 7.Install new receiver drier or accumulator and new orifice tube or expansion valve. 8.Evacuate the A/C system for a minimum of one hour. 9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system. 10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct. 11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature. To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. Item Specifics Placement on Vehicle Front Interchange Part Number CO 4918AC,38810RNAA02,38810RRBA01,1102577,5512349 Manufacturer Part Number RUS1148580 Other Part Number 97555,98555,10361921,1102638,638880,38810-RNA-A02 Brand Unbranded Manufacturer Warranty 1 Year Type Compressor & Clutch Assembly Payment We accept Paypal,Google Pay,VISA,Master Card,American Express,Discover,eBay Mastercard payment. Shipping Pickup is not available as all items are shipped to buyers - NO EXCEPTIONS Orders ARE POSTED BY USPS OR FEDEX. Returns If you are unhappy with your purchase for any reason, US buyers can return it to us in an un-used condition in the original packaging within 30 days of purchase and we'll give you a refund or exchange. The refund/Exchange will not include postage/eBay costs. Please note you MUST contact us to obtain a Return Authorization Number before returning any part. Any parcel without the Return Authorization Number will be rejected. If your item is faulty or was incorrect, you must contact our sales representative before returning the parcel and we will endeavour to solve the problem effectively. Video or picture is required to show the item condition before we issue the Return Authorization Number. Important Notice: 1. Any returned item(s) without Return authorization number will be rejected. 2. Please return your item(s) in original packaging and ensure that all packages are securely wrapped. 3. We will not accept responsibility for loss or damage of goods during transit, please ensure that the insurance cover option is taken where possible. Feedback If you have purchased the wrong Good or are returning a Good as a warranty claim, we will accept a return of that good and issue refund or send out a replacement Good subject to the following:you must contact us first about the Goods before returning the Goods to us, and if we agree to accept a return of the incorrectly purchased Good or if we agree to accept the warranty claim over the Good then you MUST do the following:the Goods must be securely and appropriately packed so they are not damaged during transit;the Goods must be returned in their original packaging;the Goods must be like new and not show any signs of use or having been installed or fitted;The claim for refund must be advised to us no later than 30 days after the date you bought the Good. About Us ● High Quality ● Customer - Service ● Affordable Prices DESCRIPTION PAYMENT SHIPPING RETURN POLICY CONTACT US Store Category Store Home Auto Engine System ◈ Engine Mounts ◈ Engine Oil Pan ◈ Engine Timing Cover ◈ Engine Protective Device ◈ Valve Lifters & Components ◈ Automobile Oil Filter ◈ Other Suspension ◈ Swar Bar ◈ Control Arms & Parts ◈ Suspension Other ◈ Other Ignition System ◈ Ignition Switch & Module ◈ Ignition Coil ◈ Other Valve Train ◈ Tensioner ◈ Valve Drive Set ◈ Valve Set Starting System ◈ Transmission Control Mechanism Crank Connecting Rod Mechanism ◈ Valve Cover & Gasket Lubrication System ◈ Oil Filter & Pump Other Hot Item 12Pcs For 2011-2017 Ford Explorer Front Lower Control Arm Ball Joint Tie Rod End USD 173.43 For 1969-77 Chevrolet Chevelle Buick GS GM Cars TH400 Kickdown Switch 1242101 USD 14.91 Oxygen Sensor Upstream For Honda Civic 2006-2011 1.8L L4 36531-RNA-A01 USD 16.78 Fuel Pressure Regulator/Upgraded Blue Spring Kit For 99-03 Ford Powerstroke 7.3L USD 11.61 For 07-13 Mercedes W204 C300 C350 4 ABS Wheel Speed Sensor Front Rear Left&Right USD 31.75 New List Item Engine Crankshaft & Con Rods & Bearings Set For Hyundai Kia 2.4L 2011-2019 2020 USD 130.82 D3SZ4026A For Ford All Ratios 9" Inch Trac-Loc Posi w/ 28 Splines Traction Lock USD 225.36 3925400 Cylinder Head W/Valves & Spring For Dodge 1994-1998 Ram 2500 3500 5.9L USD 543.92 For Honda Odyssey 2005 2006-2014 3.5L Timing Belt Kit Water Pump 14400-RCA-A01 USD 49.26 For Toyota 2RZFE 3RZFE 2.4L 2.7L 94-00 Cylinder Head Head Gasket Set 11101-79276 USD 672.70 A/C Compressor w/Clutch CO 4918AC For 2007 2008-2011 Honda Civic 1.8L Fitment: For 2006 2007 2008 2009 2010 2011 Honda Civic 1.8L Note: Each AC air compressor comes with about 80ML of Oil. You dont need to add oil additionally. This compressor comes pre-filled with the correct amount of oil. Thus, there is no need to add any additional oil to your system. Please add refrigerant to 70-80% without filling up. There may be noise if the refrigerant is added too much. Description： Interchange Part Number: CO 4918AC,38810RNAA02,38810RRBA01,1102577,5512349,6512349,7512349,97555,98555,10361921,1102638,638880, 38810-RNA-A02,38810-RRB-A01 Installation Method Attention Please: Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken. 1. Remove compressor: Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped). 2.receiver drier or accumulator, orifice tube or expansion valve. 3.Disconnect the negative battery cable. 4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet. 5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too. 6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated. 7.Install new receiver drier or accumulator and new orifice tube or expansion valve. 8.Evacuate the A/C system for a minimum of one hour. 9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system. 10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct. 11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature. To confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the Compatibility Table. Item Specifics Placement on Vehicle : Front Interchange Part Number : CO 4918AC,38810RNAA02,38810RRBA01,1102577,5512349 Manufacturer Part Number : RUS1148580 Other Part Number : 97555,98555,10361921,1102638,638880,38810-RNA-A02 Brand : Unbranded Manufacturer Warranty : 1 Year Type : Compressor & Clutch Assembly Payment Shipping Returns Feedback About Us We accept Paypal,Google Pay,VISA,Master Card,American Express,Discover,eBay Mastercard payment. Pickup is not available as all items are shipped to buyers - NO EXCEPTIONS Orders ARE POSTED BY USPS OR FEDEX. If you are unhappy with your purchase for any reason, US buyers can return it to us in an un-used condition in the original packaging within 30 days of purchase and we'll give you a refund or exchange. The refund/Exchange will not include postage/eBay costs. Please note you MUST contact us to obtain a Return Authorization Number before returning any part. Any parcel without the Return Authorization Number will be rejected. If your item is faulty or was incorrect, you must contact our sales representative before returning the parcel and we will endeavour to solve the problem effectively. Video or picture is required to show the item condition before we issue the Return Authorization Number. Important Notice: 1. Any returned item(s) without Return authorization number will be rejected. 2. Please return your item(s) in original packaging and ensure that all packages are securely wrapped. 3. We will not accept responsibility for loss or damage of goods during transit, please ensure that the insurance cover option is taken where possible. If you have purchased the wrong Good or are returning a Good as a warranty claim, we will accept a return of that good and issue refund or send out a replacement Good subject to the following:you must contact us first about the Goods before returning the Goods to us, and if we agree to accept a return of the incorrectly purchased Good or if we agree to accept the warranty claim over the Good then you MUST do the following:the Goods must be securely and appropriately packed so they are not damaged during transit;the Goods must be returned in their original packaging;the Goods must be like new and not show any signs of use or having been installed or fitted;The claim for refund must be advised to us no later than 30 days after the date you bought the Good. ● High Quality ● Customer - Service ● Affordable Prices All rights reserved. On Jun 6, 2025 at 14:42:12 PDT, seller added the following information: